Autel IM608 All Keys Lost Programming for Range Rover Evoque 2013

This article show a guide how to use Autel MaxiIM 608 to program new keys for Range Rover Evoque 2013all keys lost.

Procedures:

Build connection between Key Programmer Autel IM608 and Range Rover Evoque 2013.

Select “Manual Selection”

Select Range Rover Evoque

Select “-2013 Smart Key”

Keyless System(CAN)

Select “All Smart Keys Lost”

Now please press START botton

Note:

1.All of the learned smart keys will be earased,there must be at least two smart keys need to be learned

2.The original vehicle key need to do “Recover Smart key” function at first

Please turn the ignition Off

Was the ignition automatically turned on.

After then it will show you the vehicle information as below

The number of learned keys is 0

All smart keys were erased,Please learn new smart keys

Put the learning smart key on your hand.

Now press Unlock button of the smart key to be learned for 1s within 5s,if the vehicle does not respond,a few more times.

Learning successfully.

Please continue to learn the next one.

Jut repeat the procedures above.

Autel IM608 Adds 2010 Chrysler Town & Country Keys

Autel MaxiIM IM608 did successfully pull the pin on a 2006 Dodge and I’m gonna show another 2010 Chrysler Town and Country.

Auto detect.

Auto scan VIN.

Chrysler (USA).

Diagnostic program loading.

Smart Mode.

Read the message.

Establishing vehicle communication.

Select “Smart Key”.

Switch the ignition OFF and then ON again, make sure the engine is off.

Establishing vehicle communication.

The password is 3679.

Select “Read Immobilizer Password (CAN)”.

Go to “Key Learning” again.

Tap “OK”

Establishing vehicle communication.

Learning failed.

I guess I should have the new key there.

Turn the ignition off and pull out the current key. Insert another key to be programmed, turn the ignition on, and make sure the engine has not been started.

Establishing vehicle communication.

Current number of keys is: 3

Learning successful.

I don’t want to learn the next key, let’s see if it works.

This is the new key, and I press the “Unlock button” it can start the car, nice.

This is the old key.

So. Success. As you can see, you did not need to connect the programmer, you can directly connect Autel IM608 to the Chrysler via OBD.

Autel IM608 Read Immo Data from BMW FEM M95128

In this introduction,OBD2TOOL will show you guide on how to use Autel MaxiIM IM608 to read out immobilizer data from BMW FEM M95128 chip.

Procedures:

Connect XP400 programmer to Autel IM608 tool,then use APA103 clamp to connect EEPROM to XP400.

Then select “IMMO”–>”BMW”–>”System Selection”–>”Immobilizer”

Select “FEM/BDC immobilizer”

Select “EEPROM operation”

Here you can select “Diagram” to check the connection

FEM-M95128

Scroll download to check “BDC M95256”

And position of pins on EEPROM

In this expamle,it is M95128,here we back to menu to select “95128”

Select “Read operation”

Reading EEPROM,please wait…

When finish,you can save it.